Setting Up Pcs On A Network - NEC Express 5800 User Manual

SETTING UP PCS ON A NETWORK

If you have computers running on Windows Server 2003, Windows XP/2000/NT4.0, Windows 95/98
that communicate with NEC Express5800/ft series using the TCP/IP protocol, make the following
settings on all computers.
1.
Copy the following in the EXPRESSBUILDER CD-ROM or ft control software, UPDATE
CD-ROM to any directory.
\STRATUS\LANG\EN\PROG\FTREG.EXE
TIPS:
ft Update CD is for updating ft control software. It may not be attached to the
product. If software included in the EXPRESSBUILDER CD-ROM is latest at the time
of shipment, the ft Update CD is not attached.
2.
Start up the command prompt and enter the directory in which the file mentioned above is
copied, and then enter the following command.
FTREG.EXE
This setting is to avoid a timeout caused by non-communication state between the NEC
Express5800/ft series and computers connected by the LAN protocol that may occur
immediately after the NEC Express5800/ft series startup or a CPU module reinstallation (dual
processing).
Non-communication time immediately after the NEC Express5800/ft series startup or module
reinstallation in the system where Windows Server 2003 runs is proportional to the size of
memory mounted and how much applications running use memory.
Procedures after Completion of Installation 4-21