NEC Express 5800 User Manual page 110

5-12 Troubleshooting
4) Click the [Change/Remove] button.
At that time, the message on dialog box will be displayed.
This is a message for confirmation of deletion, so click [OK] button.
5) Close the [Add or Remove Programs] dialog box.
6) Reboot the system.
IMPORTANT:
system. If you perform the next procedure (installation of PROSet II) without rebooting,
PROSet II does not start after reboot. The system may become unstable.
4.
After rebooting the system, log on to the system as a user with Administrative rights.
IMPORTANT:
(Check that STATUS2 LED of each PCI module stays green.)
5.
Follow the steps below to update the system:
If you do not have NEC Express5800/ft series ft Update CD (and use NEC
EXPRESSBUILDER CD-ROM):
a) After logging in to the system as an account (such as Administrator), insert NEC
EXPRESSBUILDER CD-ROM into the drive.
b) On the "Master Controller Menu" screen that appears, click [Setup] and click [Update
NEC Express5800 system] on the menu.
c) Follow the messages that appear on the screen to continue.
If you have NEC Express5800/ft series ft Update CD:
a) After logging in to the system as an account (such as Administrator), insert the UPDATE
CD-ROM into the drive.
b) From [Start] of the taskbar, select [Run...] to run CD-ROM
drive:\WINNT\DOTNET\FTUPDATE.VBS.
c) Follow the messages that appear on the screen to continue.
6.
After the update procedure is completed, the system will reboot automatically.
Remove the CD-ROM from the CD-ROM drive when the system restarts.
Be sure to perform the following procedure No.6 after rebooting the
Check the dual system is configured properly.