NEC Express 5800 User Manual page 69

Select [Stratus emb-82559 10/100
4.
Enet Adapter] from Network
Component Tree. The pop-up
menu appears. Select [Add to
Team] → [Team #1: Adaptive
Fault Tolerance Mode], and add
the adapters.
You will see the warning message
when you add the team. You can
ignore this warning message by
clicking [OK].
message is to inform you that only
one adapter is added to the team.
Select [Stratus emb-82559 10/100 Enet Adapter #2] from Network Component Tree in the
5.
same manner as for step 4. The pop-up menu appears. Select [Add to Team] → [Team #1:
Adaptive Fault Tolerance Mode], and add the adapters.
Do not set [Preferred Primary] or [Preferred Secondary] to each adapter.
IMPORTANT:
Make settings of dual configuration for "Stratus emb-82544GC Copper Gigabit Adapter"
6.
(1000Base) as well.
Perform Steps 3 to 5 in the same manner, replacing [Stratus emb-82559 10/100 Enet Adapter]
with [Stratus emb-82544GC Copper Gigabit Adapter].
In Step 3, you can also select [Load Balancing]. In this case, [Team #X: Adaptive Load
Balancing Mode] will be added.
Click [OK].
7.
The [Intel(R)PROSet II] dialog
box closes after a while, and the
settings become effective.
IMPORTANT:
[Digital signature not found]
dialog box may appear
(several times). If it appears,
click [Yes].
After the settings of dual
configuration, "Intel(R)
Advanced Network Services
Virtual Adapter" will appear
on [Network and dialup connection] or [Device Manager] dialog box. Do not
"disable" the status of this adapter. If you enable it again, the system may become
unstable and you may need to restart it.
This warning
Windows Setup 3-29