Updating The System - NEC Express 5800 User Manual

Updating the System

IMPORTANT:
NEC Express5800/ft series is a precision instrument. You should ask maintenance
personnel to update the system.
You will need to update the system after you repair the system using Recovery Console.
IMPORTANT:
Make sure to follow the steps below when you have restored the
Console.
Check the BIOS settings.
If [Boot Monitoring] selected in [Monitoring Configuration] of [Advanced] is not set to
"Disable", disable it. For more information, see "SWITCHING BOOT MONITORING
FUNCTION ~CHANGING BIOS SETTINGS~" in Chapter 3.
1.
Log on to the system with OS installed as user with Administrator authority.
IMPORTANT:
STATUS2 LED of each PCI module stays green.)
2.
Remove duplication of LAN for both onboard and option boards.
IMPORTANT:
Note down the setup information.
1) Display the [Intel(R)PROSet II] dialog box.
2) Start up one of the following start menu modes by according to its procedures.
Standard startup menu mode:
Click the [Start] button and select [Control Panel], and then [Intel(R)PROSet II].
Classic start menu mode
(1) Click the [Start] button and select [Settings], and then [Control Panel].
(2) Double click the [Intel(R)PROSet II] icon.
3) Remove all adapters from Duplication.
Right-click the following adapters on the
control tree which is located on the left
side of [Intel(R)PROSet II] dialog box
and select [Remove from Team].
<For on-board >
- Status emb-82559 10/100 Enet
Adapter
- Status emb-82544GC Copper
Gigabit Adapter
Check that the dual system is configured properly. (Check that
When dual LAN is disabled, a setup of LAN will be deleted.
:
Troubleshooting
system by using Recovery
5-9