Sensor Adjustment; Temperature Sensor/ Temperature; Reflective Sensor/ Reflect - Toshiba B-EX4 SERIES Maintenance Manual

5. SYSTEM MODE

5.7 SENSOR ADJUSTMENT

Outline of the Sensor Adjustment
In the Sensor Adjustment mode, the status of the sensors and thermistors is displayed. Also you can
make a Threshold Setting for the Black Mark, Feed Gap, and Ribbon End Sensors.
The Sensor Adjustment menu contains the following:
MENU ITEM
System Mode / SYSTEM MODE
<5>Sensor adjustment / <5>SENSOR ADJUST
Temaprature sensor / TEMPERATURE

Reflective sensor/ REFLECT

Transmissive sensor / TRANS.
Paper end level / PE REFL./TRANS.
Ribbon end / RIBBON

5.7.1 Temperature sensor/ TEMPERATURE

It display outer temperature and head temperature.
The sign of temperature is displayed only when temperature is minus (-).
The display content is updated each 200 msec.
The range of each temperature is below.
Outer temperature
Head temperature
5.7.2 Reflective sensor / REFLECT
It adjusts the sensor level of reflective sensor.
Set tag paper on reflective sensor and the black mark should not be located on the sensor.
The display content of sensor level is updated each 200 msec.
The sensor level is adjusted by holding down [ENTER] key for 3 seconds.
When the adjustment is finished, "Adjustment complete" is displayed and asterisk (*) is marked at the
right side or voltage.
The range is below.
Reflective sensor
-20 100
-20 100
0.0V 5.0 V
5-55
EO18-33027
5.7 SENSOR ADJUSTMENT