Toshiba B-EX4 SERIES Maintenance Manual page 60

5. SYSTEM MODE
PARITY
CONTROL
<< CENTRO >>
Item
ACK/BUSY
INPUT PRIME
PLUG & PLAY
<< LAN/WLAN >>
Item
LAN/WLAN
SNMP
PRTR IP ADDRESS
GATE IP ADDRESS
SUBNET MASK
Parity selection
Transmission control
method selection
Content
Centronics
timing setting
Reset process when the
nInit signal is ON
Plug-and-play
setting
Content
LAN selection
SNMP enabled/disable
Printer IP address
Gateway IP address
Subnet mask
2 2bit
NONE Non parity.
ODD Odd parity.
EVEN Even parity.
XON/XOFF
XON/XOFF protocol
(No XON output when the power is
on, no XOFF output when the
power is off)
READY/BUSY
READY/BUSY (DTR) protocol
(No XON output when the power is
on, no XOFF output when the power
is off)
XON+READY
XON/XOFF + READY/BUSY (DTR)
AUTO
protocol
(XON output when the power is on,
XOFF output when the power is off)
XON/XOFF
XON/XOFF protocol
AUTO (XON output when the power is on,
XOFF output when the
off)
READY/BUSY
RTS protocol
RTS
(No XON output when the power is
on, no XOFF output when the
power is off )
ACK/BUSY TYPE1
TYPE2
ON
OFF
operation ON
OFF
OFF
AUTO
LAN
WLAN
ON
OFF
***.***.***.***
***.***.***.***
***.***.***.***
5-12
5.3 SELF-DIAGNOSTIC TEST
Print value
The ACK signal is sent to
match the rising edge of ACK
signal and the falling edge of
the BUSY signal.
The ACK signal is sent to
match the falling edge of ACK
signal and the falling edge of
the BUSY signal.
Reset is performed.
Reset is not performed.
Plug-and-play operation
enabled.
Plug-and-play operation
disabled.
Print value
Disabled
Auto
Wired LAN
Wireless LAN
Enable
Disable
EO18-33027
power is
is
is