Fuser Exit Roller - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Fuser exit roller

Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridge basket. Cover
the basket in a lightproof black bag and store in a safe place.
2.
Open the front cover.
3. Remove the left-side cover as detailed in the topic "Left-side cover" on
page 88.
4. Remove the right-side cover as described in the topic "Right-side
cover" on page 89.
5. Remove the right shield plate as shown in "Right shield plate" on
page 93.
6. Remove the card cage as detailed in the topic "Electrical chassis (card
cage)" on page 94.
7. Remove the two screws securing the duplex gate solenoid.
8.
Remove the screw securing the fuser exit roller ground contact.
9. Release the locking tab and remove the fuser drive gear.
10.
Remove the bearing located behind the fuser drive gear.
11.
Release the two locking tabs and remove the bearing from the left end
of the fuser exit roller shaft.
12.
Lift the duplex exit gate.
13. Slide the fuser exit roller to the right until the left end of the staff is free.
142 Phaser 1235 Network Color Printer