Motor And Clutch Tests; Motor And Clutch Test Constraints - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Motor and clutch tests

1.
Enter the diagnosis mode by pressing and holding the Menu (1) and
Enter (4) keys as you turn on the printer.
2.
Press the Menu (1, 5) keys to scroll through the list of test until
& CLUTCH TEST
Caution
Before running some motor and clutch tests you must remove
certain printer consumable items; refer to table below. The front
panel also reminds you to remove the necessary item before
starting the test.
3.
Press the Item (2, 6) keys to scroll through the list of motors and
clutches until the desired item is displayed.
4.
If indicated, remove the consumable items constraining the test.
5.
Press the Value (3) key to start the displayed test. The displayed test
item blinks, and the selected motor or clutch is driven for 10 seconds.
6.
Press the Value (7) key to stop the unit.
7. Repeat the Steps 2 to 7 for other motor or clutch tests.
8.
Press Enter (4) ends the tests.

Motor and clutch test constraints

Motor or clutch displayed
on control panel
BLACK-ID MOTOR
YELLOW-ID MOTOR
MAGENTA-ID MOTOR
CYAN-ID MOTOR
TRANSFER BELT MOTOR
FUSER MOTOR
REGISTRATION MOTOR
appears on the upper display.
Constraints
displayed on
control panel
REMOVE ID
REMOVE ID
REMOVE ID
REMOVE ID
REMOVE ID
none
none
Details
Run test with the drum unit caddy
removed.
Run test with the drum unit caddy
removed.
Run test with the drum unit caddy
removed.
Run test with the drum unit caddy
removed.
Run test with the drum unit caddy
removed.
Remove the fuser and observe the fuser
drive gears turn.
Remove the drum unit caddy and observe
the registration roller B turn
Service Guide
MOTOR
69