Installing Batteries In The Remote Control; Using A Remote Control; The Vcr/Dvd Recorder Switching - FUNAI Symphonic CWR20V5 Owner's Manual

Installing batteries in the remote control

Install two "AA" size batteries (supplied), matching
their polarity to those indicated inside battery com-
partment of the remote control.
1
2
Note:
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please follow the instruction
below:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery com-
partment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing used batteries, please comply with
governmental regulations or public rules for envi-
ronmental protection that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or disas-
semble batteries.

The VCR/DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which com-
ponent you wish to operate with [SELECT].
VCR MODE
Press [VCR] on the remote control.
(Verify that the VCR indicator is lit.)
DVD MODE
Press [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Notes:
• Pressing only [SELECT] on the front panel
DOES NOT switch the mode of the remote
control.You MUST select the correct mode on
the remote control.
• You cannot switch to another mode (DVD or
VCR) during in the timer-standby mode.
• Pressing [REC/OTR] (DVD) or [REC/OTR]
(VCR) on the remote control switches immedi-
ately its respective mode so that you can start
recording directly on the appropriate media.
10
Before you start
Functional overview (cont'd)
3

Using a remote control

Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor of the
unit.
• Remote operation may become unreliable if
strong sunlight or fluorescent light is on the
remote sensor of the unit.
• Remote control for different devices can inter-
fere with each other. Avoid using remote control
for other equipment located close to the unit.
• Replace the batteries when you notice a fall-off
of the operating range of the remote control.
• The maximum operable ranges from the unit are
as follows.
- Beeline: approx. 23 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx. 10 feet (3m) within 30°
Within about
POW
ER
23feet (7m)
30˚
30˚
Remote
control
SELECT button
OPEN/CLOSE
REW F.FWD STOP/EJECT PLAY RECORD CHANNEL DUBBING SELECT
POWER
VCR
VCR SELECT DVD
REW
F.FW
D STO
P/EJ ECT
PLA
Y
REC ORD
OPE
N/CL
OSE
CHA
NNE L
DUB
BING
SEL
ECT
STO
P
PLA Y
VCR REC
ORD
SEL ECT
DVD
S-V IDEO
VIDE
O
L- AUD
IO- R
POWER
T-SET TIMER PROG.
.@/:
ABC
1 2
GHI JKL
STOP PLAY RECORD
4 5
PQRS TUV
SELECT DVD
7 8
S-VIDEO VIDEO L- AUDIO- R
DISPLAY SPACE
0
TOP MENU MENU/LIST
VCR button
REC/OTR VCR
DVD button
REC SPEED
REC MONITOR SKIP
SLOW CM SKIP
DVD indicator
DUBBING ZOOM
VCR indicator
OPEN/CLOSE
DEF
3
MNO CH
6
WXYZ VIDEO/TV
9
CLEAR SETUP
RETURN ENTER
DVD REC/OTR
PLAY
PAUSE SKIP
STOP SEARCH
AUDIO