Dell PowerEdge systems 6300 User Manual page 55

NOTE: To load the driver from your hard-disk drive, the aic78u2.ham driver and
nwaspi.cdm module must be copied from your NetWare 4.11 driver diskette to a
directory on your hard-disk drive (usually, the server's start-up directory [for example,
c:\nwserver ]).
The syntax to load the aic78u2.ham driver follows:
load [ pathname ]\aic78u2.ham [ options ] slot= x
For example, the command line to load the driver from the c:\nwserver directory with
the verbose= option on and a slot number of 10002 follows:
load c:\nwserver\aic78u2.ham verbose=y slot=10002
NOTE: For each Adaptec 78 xx host adapter installed, a separate load command line
must be included in the startup.ncf file. The slot number ( slot= ) identifies the specific
adapter.
To modify the startup.ncf file, follow these steps:
install
The aha2940.ham driver module fully supports removable-media disk drives, includ-
ing magneto-optical drives. Removable media is treated as a standard SCSI hard-disk
drive, with some exceptions:
The driver only recognizes and registers media with 512 bytes/sector.
NetWare allows you to mount or dismount the media and lock or unlock the
media.
These removable media options are supported by NetWare's monitor.nlm program.
Follow these steps to set up the removable media:
All system hard-disk drives appear.
Drive status items appear as shown in Table 3-2.
Installing and Configuring SCSI Drivers 3-23