TRENDnet TEW-750DAP User Manual page 19

TRENDnet User's Guide
PBC (Software/Virtual Push Button)
Wireless > Wi-Fi Protected Setup
In addition to the hardware push button located physically on your access point, the
access point management page also has push button which is a software or virtual push
button you can click to activate WPS on your access point.
1. Log into your access point management page (see
management page" on page 11).
2. Click on Wireless, and click on Wi-Fi Protected Setup.
3. To add a wireless device to your network, click the Connect button in the access point
management page.
4. Make sure Auto is selected and click Next.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your access point
5. Select PBC and click Connect. Then push the WPS button on the wireless device
(consult wireless device's User's Guide for length of time) you are connecting.
6. Wait for your access point to finsh the WPS process.
7. If successful, you will receive the message below. Click on Wireless Status to view the
information about the current wireless client devices connected to your access point.
TEW-750DAP
16