Secure Your Wireless Network - TRENDnet TEW-750DAP User Manual

TRENDnet User's Guide

Secure your wireless network

Wireless > Basic
After you have determined which security type to use for your wireless network (see
"How to choose the security type for your wireless
wireless security.
Note: By default, your access point is configured with a predefined wireless network
name (SSID) and security key using WPA2-Personal. The predefined wireless network
name and security can be found on the sticker on the side of the access point or on the
device label at the bottom of the access point.
1. Log into your access point management page (see
management page" on page 11).
2. Click on Wireless, and click on Basic.
4. Under Wireless Security Mode (2.4GHz or 5GHz), click on the Security Mode drop-
down list to select your wireless security type.
© Copyright 2013 TRENDnet. All Rights Reserved.
network" on page 12), you can set up
"Access your access point
Selecting WEP:
If selecting WEP (Wired Equivalent Privacy), please review the WEP settings to configure
and click Save Settings to save the changes.
• WEP Key Length: Choose the key length 64-bit or 128-bit .
Note: It is recommended to use 128-bit because it is more secure to use a key that
consists of more characters.
• Authentication: Choose Both or Shared.
Note: It is recommended to use Both which includes both Open and Shared. Open
is known to be more secure than Shared Key.
o WEP Key: Enter the WEP key. This is the password or key that is used to connect
your computer to this access point wirelessly.
WEP Key Format HEX
Character set 0-9 & A-F, a-f only
64-bit key length 10 characters
128-bit key length
26 characters
TEW-750DAP
ASCII
Alphanumeric (a,b,C,?,*, /,1,2, etc.)
5 characters
13 characters
13