Installing A Pcie Card - HP Z600 Maintenance And Service Manual

Installing a PCIe card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
NOTE:
the card support is removed, allowing access to the expansion cards.
3. Select the desired expansion card slot for the PCIe card. (See
on page 132
4. Push the expansion card retention clamp levers down on the outside of the chassis to release the
retention clamp as shown in the following figure
Figure 5-77
5. Remove the PCI slot cover by pulling it up, out of the chassis
TIP: Grasp the slot cover between two fingers—one from the inside of the chassis, and one from
the outside.
134 Chapter 5 Replacing components
An expansion card support is built into the side access panel. When the panel is removed,
for help in selecting a slot.)
Removing the slot cover
Predisassembly procedures on page
Removing the side access panel on page
.
73).
75).
Choosing an expansion card slot
.
2
ENWW