Installing A 3.5-Inch Device - HP ProDesk 400 G2 Small Form Factor Maintenance And Service Manual

5. Disconnect the drive cables from the rear of the drive, or, if you are removing a media card reader,
disconnect the USB cable from the system board as indicated in the following illustration.
6. Press inward on the release lever at the rear of the device (1) and slide the device out of the rear of the
drive bay (2).

Installing a 3.5-inch device

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
blank, remove the bezel blank. See
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 21). If you are installing a drive in a bay covered by a bezel
Bezel blanks on page 23
20).
for more information.
19).
Drives 35