IBM Infoprint 6500-v05 Maintenance Manual page 469

8. Remove the two 10-32 x 5/32 inch buttonhead screws and washers securing the vertical rails to the upper frame cross-
member at the rear of the cabinet. (Figure 66.)
9. Remove the two Torx T-10 screws securing the stacker base to the cabinet floor. (Figure 66.)
10. Remove the two Torx T-10 screws that secure the rail bracket to the cabinet floor. (Figure 66.)
Upper Frame
Cross-Member
Left Vertical Rail
Washer
Left Screw, 10-32 x 5/32 inch
Screw,
Torx T-10
(2 places)
Figure 66. This figure shows which screws to remove to prepare the stacker for removal from the cabinet.
Right Vertical Rail
Stacker Base
Screw,
Torx T-10
Washer
Right Screw, 10-32 x 5/32 inch
Screw,
Torx T-10
469