IBM Infoprint 6500-v05 Maintenance Manual page 136

Operator Panel Message
191 SECURITY VIOLATION
194 INCOMPAT. E-NET NIC
REPLACE NIC
Table 3. Message List
Explanation
Security code of the security key
on the controller board does not
match the code of the firmware on
the controller board.
The ethernet NIC installed in the
printer is not the correct part
number for a 6500-v printer.
Corrective Action
1. Power off and unplug the printer. Remove the paper guide
assembly or pedestal top cover. Check the security key at
connector J9 on the controller board. The security key is a 3-pin
jumper connector. If it is absent, install the correct key for the
customer's emulations. If a key is present, replace it.
2. Plug in the printer and power it on. If the message appears, the
controller board or microcode is suspect. Do the following:
3. Save the printer configuration values. (Refer to the User's
Manual .)
4. Clear NVRAM (page 237).
5. Download and install the latest code from IBM First (page 231).
6. Power on the printer in download mode and load flash memory
(page 238).
a. If you encounter loading problems, go to the appropriate error
code for resolution.
b. If you encounter the failure or message that brought you to
this procedure, replace the controller board (page 319). After
replacing the controller board, DO NOT make the printer
READY, but proceed immediately to the next step.
7. Download and install the latest code from IBM First (page 231).
8. Power on the printer in download mode and load flash memory
(page 238).
9. If you encounter the failure after replacing the controller board,
reinstall the original controller board and contact your DDS and
Second Level Support.
Remove the NIC and replace it with a NIC with the correct part
number for this printer.
Display Messages
136