IBM Infoprint 6500-v05 Maintenance Manual page 151

Operator Panel Message
ENERGY SAVER MODE
E Net Test Unavailable
Table 3. Message List
Explanation
Status message: the printer is in
low-energy idle state, all fans and
higher voltages are off, only
+5VDC logic circuits are active.
The Ethernet PCBA did not
initialize correctly.
Corrective Action
No action required.
1. Cycle power. Wait for "E Net Ready" to display, then retry
operation. If it still fails, power down, unplug the printer, and
reseat the ethernet NIC in its PCI slot.
2. Print the Ethernet Test Page from the Operator Print Tests.
3. Verify that the IP address, subnet mask, and default gateway
address are correct in the printout.
4. Verify that the IP address can be "pinged."
5. If the message still appears, replace the ethernet NIC.
Display Messages
151