IBM Infoprint 6500-v05 Maintenance Manual page 156

Operator Panel Message
ERROR: FLASH
NOT DETECTED
Table 3. Message List
Explanation
The printer could not find flash
memory.
Corrective Action
1. Power off and unplug the printer. Check flash memory on the
controller board. If present, reseat the flash SIMM; if missing,
install a new flash SIMM. After replacing the memory, DO NOT
make the printer READY, but go to the next step immediately.
2. Download the latest code from IBM First (page 231).
3. Plug in the printer and power it on in download mode and load
flash memory (page 238). If the message appears again, replace
the flash memory SIMM.
4. Load flash memory (page 238).
5. Power on the printer. If the message appears, the controller board
or microcode is suspect. Do the following:
6. Save the printer configuration values. (Refer to the User's
Manual .)
7. Clear NVRAM (page 237).
8. Download and install the latest code from IBM First (page 231).
9. Power on the printer in download mode and load flash memory
(page 238).
a. If you encounter loading problems, go to the appropriate error
code for resolution.
b. If you encounter the failure or message that brought you to
this procedure, replace the controller board (page 319). After
replacing the controller board, DO NOT make the printer
READY, but proceed immediately to the next step.
10. Download and install the latest code from IBM First (page 231).
11. Power on the printer in download mode, and load flash memory
(page 238).
12. If you encounter the failure after replacing the controller board,
reinstall the original controller board and contact your DDS and
Second Level Support.
Display Messages
156