Original Placement Indicator - Kyocera KM-2540 Operation Manual

Preparation for Usage
2
Place the originals. Put the side to be scanned (or the first side of
two-sided originals) face-up. Slide the leading edge into the
document processor as far as it will go. The original placement
indicator will be lit.
IMPORTANT Confirm that the original width guides exactly fit the
originals. If there is a gap, readjust the guides. The gap may
cause the originals to jam.
Ensure that loaded originals do not exceed the level indicator. If
exceeded, originals may jam (see the figure).
Originals with punched holes or perforated lines should be placed
such that the holes or perforations will be scanned last (not first).

Original placement indicator

The original placement indicator is lit depending on how originals are
placed.
Indications and their status are as follows.
• Green (upper indicator) lit: Original is placed properly.
• Green (upper indicator) blinking: Original is not placed properly.
Remove and place again.
• Red (lower indicator) blinking: Original is jammed. Remove the
jammed original and place it properly.
2-17