Canon imagePROGRAF iPF760 User Manual page 499

iPF760
Adjust Feed Pri-
Adjust
Printer ority
Length
Mainte- Head Cleaning
nance
Nozzle Check
Replace P.head
Repl. maint cart
Head Info
GL2 Replot
GL2 BufferClear
GL2 Set- Quality Color
tings Manager Mode
Print Quality
Input Resolution
Print (Economy)
Paper Paper Source
Manager
Margin
User's Guide
Setting Item
Adjust- A:High
ment-
B:Standard/Draft
Print
Change A:High
Settings
B:Standard/Draft
Monochrome
Color (CAD) 1
Color (CAD) 2
Color (CAD) 3
Color (CAD) 4
Color (CAD) 5
Description, Instructions
Print a test pattern for particular types of paper to compensate
for paper stretching or shrinkage, after which you enter the
amount of adjustment. (See "Adjusting Line Length (Adjust
Length).")
→P.564
Displayed when you have selected Feed Priority > Adj. Prior-
ity > Print Length.
Adjustment relative to the amount of stretching or shrinkage of
the current paper.
Enter either the adjustment results from AdjustmentPrint or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower adjust-
ment value.
Clean the Printhead. (See "Cleaning the Printhead.")
→P.576
Choose Head Cleaning A if printing is faint, oddly colored, or
contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or if printing
is not improved by Head Cleaning A.
Print a test pattern to check the nozzles.
When replacing the Printhead, choose Yes and follow the in-
structions on the screen. (See "Replacing the Printhead.")
→P.577
Not displayed during a warning message that the remaining
Maintenance Cartridge capacity is low.
When replacing the Maintenance Cartridge, choose Yes and
follow the instructions on the screen. (See "Replacing the
Maintenance Cartridge.")
→P.584
Indicates information about the printhead.
Print the previous GL2 print job again.
Clear the print data in the replot buffer.
Print in monochrome.
Print in standard colors.
Print in brighter colors.
Print emulating the following printers, in colors resembling col-
ors produced by these printers: Canon iPF500, iPF600,
iPF700, iPF510, iPF610, iPF710, iPF605, iPF720, iPF810,
iPF815, iPF820, and iPF825. ( *2 )
Print emulating the HP Designjet 500/800, in colors resembling
colors produced by these printers.( *2 )
Print emulating the HP Designjet 1000, in colors resembling
colors produced by this printer.( *2 )
Choose the print quality.
Choose the printer input resolution, 600dpi or 300dpi.
Although printing quality is diminished, less ink is consumed
than in regular printing. Select On to conserve ink.
Choose the source of paper for HP-GL/2 printing.
Specify the margin around paper. The margin for the trailing
edge of sheets is 23 mm (0.9 in).
Menu Settings
499