Base Power Communication Indicator; Reset Scanner; Scanning While In Base Cradle - Honeywell Xenon 1900 User Manual

Green LED
Off
Slow flash, 1 second on, 1 second off
On continuously
Fast flash, 300 mSec on, 300 mSec off

Base Power Communication Indicator

To display the power indicator on a base or an Access Point, scan the Base
Power Communication Indicator On bar code. To turn off the power indi-
cator, scan the Off bar code. Default = On .
* Base Power Communication

Reset Scanner

Scanning this bar code reboots the scanner and causes it to relink with the base
or Access Point.

Scanning While in Base Cradle

Note: This feature only applies to the CCB01-010BT base.
If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scanning in Cradle On bar code below. If you want to only allow
scanning when the scanner is out of the base cradle, scan Scanning in Cradle
Green LED - Scanner Battery
(base only, does not apply to Access Point)
Indicator On
Reset Scanner
Charge Condition
Battery not detected or charge
suspended
Pre-charge and charging
Charge complete
Charge Error
Base Power Communication
Indicator Off
3 - 9