Vlan Routing Ospf Configuration - Dell Force10 S2410-01-10GE-24P Configuration Manual

4. As above, create VLAN 200 on switch R2, add an IP address, subnet mask, and port 2 to it:
R1 (Config)#interface vlan 200
R1 (Conf-if-vl-200)#ip address 10.11.12.144 255.255.255.0
R1 (Conf-if-vl-200)#tagged 1/0/2
5. Verify configurations with the

VLAN Routing OSPF Configuration

As described in
preference to RIP for routing in larger networks. This section provides an example of configuring VLAN
routing using OSPF. The example adds support for OSPF to the configuration created in the base VLAN
routing example
configure the S-Series as an inter-area router.
Figure 17-242. OSPF on an S50 Acting as an Inter-area Router Running VLAN Routing
1. Enable routing for the switch:
Figure 17-243. Enabling Routing for the Switch
Force10 #config
Force10 (Config)#ip routing
Force10 (Config)#exit
2. Create the VLANs and enable OSPF for the VLAN.
264 | Layer 3 Routing
show vlan id
OSPF Configuration on page
(VLAN Routing on page
command on each switch.
257, Open Shortest Path First (OSPF) is generally used in
262). The example shows the commands you would use to