Figure 14-181. Using the show vlan id Command
(R1) #show vlan id 3
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface
Vlan Id
-------
G
3
Notes:
•
The 'G' indicates that this VLAN was dynamically created via GVRP on R1.
•
If you execute
actually configured on R2, not dynamically negotiated.
•
To make the VLAN permanent on R1, use the
Displaying GARP, GVRP, GMRP Properties
These Privileged Exec and User Exec mode commands display GARP, GVRP, and GMRP information:
•
show garp
•
show gmrp configuration {
•
show gvrp configuration {
See also the
show garp and show gvrp configuration all commands
Figure 14-182. Using the show garp and show gvrp configuration all Commands
(R2) #show garp
GMRP Admin Mode................................ Disable
GVRP Admin Mode................................ Enable
(R2) #show gvrp configuration all
Slot/Port
-----------
1/0/1
1/0/2
1/0/3
1/0/4
1/0/5
1/0/6
!---------output truncated--------!
222
|
VLANs
Status
Q
Ports
---------
-
--------
Active
T
E
1/0/2
show vlan id 3
(Figure
14-182)
— Displays admin mode for GVRP and GMRP
unit/slot/port
unit/slot/port
— Port admin mode for GVRP and GMRP
— Timer values
show vlan id
command shown above
Join
Leave
Timer
Timer
-------
-------
----------
20
60
20
60
20
60
20
60
20
60
20
60
on R2, you will not see the G in the output, because the VLAN was
makestatic
| all}
| all}
(Figure
14-182)
(Figure
14-181).
LeaveAll
Port
Timer
GVRP Mode
-----------
1000
Enabled
1000
Enabled
1000
Enabled
1000
Enabled
1000
Enabled
1000
Enabled
command under
interface vlan 3
.