Figure 17-254. VRRP Example Network Configuration
Port 0/2
192.150.2.1
Virtual Router ID 20
Virtual Addr. 192.150.2.1
Configuring VRRP: Master Router (Router 1)
1. Enable routing for Router 1. IP forwarding will then be enabled by default.
Figure 17-255. Enabling Routing for a Switch
Force10 # config
Force10 (Config)#ip routing
Force10 (Config)#exit
2. VRRP is enabled by default for the router. If VRRP has been disabled, enable it:
Figure 17-256. Enabling VRRP for a Switch
Force10 (Config)#ip vrrp
Force10 (Config)#exit
3. Configure the port on Router 1 that will participate in the VRRP group:
272
|
Layer 3 Routing
Layer 3 Switch acting
Layer 3 Switch acting
as Router 1
/24
Hosts
as Router 2
Layer 2 Switch
Port 0/4
192.150.2.4/24
Virtual Router ID 20
Virtual Addr. 192.150.2.1