When Problems Occur
Sending Documents
Canceling transmissions.
Q
A
Q
A
Document cannot be sent.
Q
A
Q
11
A
Q
A
11-2
When Problems Occur
Do you want to cancel a transmission while a document is being scanned?
Press
(Stop) on the control panel, or press [Cancel] on the touch panel
display.
Do you want to cancel a transmission after a document has been scanned?
If you are sending the document by any other sending method besides fax,
press [System Monitor] ➞ [RX/TX] ➞ [TX Job Status] ➞ select the document
that you want to cancel ➞ press [Cancel] ➞ [Yes]. However, documents that are
being sent may not be canceled even if you press [Cancel]. (See "Using the
System Monitor Screen," on p. 1-42.)
If you want to cancel a fax transmission, see Chapter 1, "Introduction to Fax
Functions," in the Facsimile Guide.
Is the destination setting correct?
Check the destination setting of the recipient.
Is the destination stored in the Address Book correct?
Check the destination in the Address Book. (See "Editing Address Details," on
p. 8-20.)
Has any trouble occurred in the recipient's machine?
Check to ensure that the recipient's machine can receive documents. If it
cannot, check to see whether the machine is turned OFF, is out of recording
paper, or has insufficient available memory.