Messages Displayed When Using the Printer
Function
This section describes the principal messages that appear on the panel display. If a message not described
here appears, act according to the message.
Status Messages
This section describes the machine status messages.
Message
"Hex Dump Mode"
"Offline"
"Please wait..."
"Ready"
"Resetting job"
"Setting change..."
"Waiting for print data..."
"Job Suspended..."
Messages Displayed When Using the Printer Function
In the Hex Dump mode, the machine receives data in
hexadecimal format. Turn off the machine after printing, and
then turn back on.
The machine is offline. To start printing, switch the machine
online by pressing the [Online] key.
This message might appear for a second or two while the
machine is preparing, performing initial adjustments, or
adding toner. Wait a while.
This is the default ready message. The machine is ready for
use. No action is required.
The machine is resetting the print job. Wait until "Ready"
appears on the display panel.
The machine is setting changing. You cannot use the control
panel while this message is displayed. Wait a while.
The machine is waiting for the next data to print. Wait a while.
Printing was temporarily stopped by SmartDeviceMonitor for
Client.
You can resume printing via [My Job List] in
SmartDeviceMonitor for Client, or via the Web Image
Monitor To resume printing via Web Image Monitor, check
with your system administrator first.
Status
4
55