Table of Contents
Advertisement
3.3 Leveling the Fryer (cont.)
• Legs (Only)
1. Adjust leg height with an adjustable or 1
the hex bullet on the bottom of the leg.
2. The hex bullet is for minor leg height adjustment only. Do not adjust more than 1 inch
(25 mm).
3. When leveling the unit, the leg body should be held firmly to keep the leg from bending
or rotating while turning the hex bullet foot to the required height.
• Rigid Casters (Only)
1. Install rigid casters on the fryer rear channel only. Legs must be installed on the front channel.
2. There are no level-adjustments for the rigid casters.
B. If the floor is uneven or has a decided slope, place the fryer on a smooth platform.
C. If the fryer is moved, re-level the fryer following the instructions given in Steps 3.3, A-C.
D. Installing Optional Swivel Casters
1. Install non-locking casters only at the rear of the unit.
2. Locking casters must be installed at the front of the unit. Locking casters allow the fryer
to be "locked" in position for safe operations.
3. Follow the same instructions for leg installations as given above in Steps 3.2, B1-B5.
Front View
Front Channel
or Rear Channel
Front or Rear Leg with
Mounting Plate
Adjust as needed
KSCF18G COOL ZONE SERIES GAS FRYERS
CHAPTER 3: INSTALLATION INSTRUCTIONS
Rear Side View
1/4-20 x 3/4 Hex Bolt
Front Channel or
Rear Channel
Leg Support Assembly
Washer
1/4-20 Hex Head Locknut
1/4-20 x 3/4 Hex Bolt
Leg and Caster (Optional) Mounting Installation
1
/
-inch (27-mm) open-end wrench by turning
16
Optional Caster-
Rear Only
Rear Caster—5" Rigid
3-3
Optional Caster-
Front Only
Front Caster—5" Swivel
w/Brake
Advertisement
Table of Contents
