Advertisement
• Press Boil key a second time to return to simmer mode.
Programming
• Remove the bezel (see annotated photo on page 3-1) Lift up and then rotate out at the
bottom, which exposes a keypad beside each timer button.
• Temperature change: Press the temperature key until the current temperature is displayed.
Enter the desired temperature with the key pad.
•
An illuminated dot between the last digit and the F indicates the change was accepted.
Temperatures below 155°F and above 210°F can't be entered. The computer will default to
its lowest setting, 155°F, upon low-temperature entry and to its highest setting, 210°F, upon
high-temperature entry.
• Time change: Press the temperature key until the display alternates between S inn and a
dashed line. Enter the desired time, in minutes and seconds, on the key pad. Press the timer
key to ensure the desired time is in place. Press the timer key a second time to stop the timer.
• Turn the controller OFF. Replace the bezel. Ensure it doesn't press against the key pads.
Raise the lid slowly. Trapped steam may escape from beneath the lid.
The electronic circuitry in your computer can be affected adversely by current
fluctuations and electrical storms. Should it fail to function or program properly for
no apparent reason, the computer should be reset by unplugging the computer
harness from the rear of the computer and plugging it back into the computer. This
could prevent a service call.
3.3
Start-Up Procedure
If this is the first time the unit is being used after installation, refer to Section 3.5,
Boiling-Out the Cookpot.
1. Before turning the equipment on, ensure that:
•
The unit is connected to the water supply.
•
The water supply is turned on.
•
The unit is plugged into an outlet of appropriate voltage (check rating plate to verify).
•
The electrical power supply to the equipment is turned on.
•
The main power switch is on.
2. Press the computer Power
If the cookpot is not full, the AutoFill will add water. When the water covers the upper float
switch, the AutoFill solenoid valve will cut off the water. If the water level drops below the
upper float switch during operation, the solenoid valve will open and add water to the cookpot.
WARING
CAUTION
CAUTION
switch.
3-3
Advertisement
