Table of Contents
Advertisement
7.3.2
When Using the Printer
Condition
Cannot print.
Is the printer switched on?
Is the Ethernet cable
disconnected or loosened?
Cannot print.
Are the network environment
settings like the activating of
protocol correctly set up?
Is the network equipment like
the hub suitable for the
automatic setting of the
frame type?
Are the NetWare file server
and print server (while in
remote printer mode)
activated?
When in remote printer
mode, is the message,
"Waiting for job" being
displayed in the NetWare
print server?
Is the printer registered in the
queue user of print queue?
The file server or network
might be overloaded.
Verification
Press the power switch to " | " to switch it on.
Switch off the power and connect the
Ethernet cable properly.
Change the protocol, NetWare to Enabled.
"4.2.1 Activating the Protocol"
Check whether the port data link lamp of the
network equipment connected to the printer
is lit.
When it is not lit, use the control panel to set
the frame type to the same value as that of
the NetWare file server.
Activate the NetWare file server and print
server (while in remote printer mode).
Activate the NetWare print server. And if the
"Waiting for job" message is not displayed,
use the network utility to check if the network
environment for DocuPrint 181/211 is
correctly set.
"4.3 Configuring Fuji Xerox Network Utility"
Use the network utility to add the user setting
of the print queue for DocuPrint 181/211.
"4.3 Configuring Fuji Xerox Network Utility"
When in remote printer mode, use the
network utility to lengthen the receive timeout
period setting.
"4.3 Configuring Fuji Xerox Network Utility"
7.3 For NetWare Environment
Solution
7
169
Advertisement
Table of Contents
