Table of Contents
Advertisement
4.3 Configuring Fuji Xerox Network Utility
When Configure is clicked and the following message is displayed, carry out the following
treatment:
1. The printer might not be switched on or connected to the network.
2. The community name of the printer might be changed. In this case,
7
4
Make your selection of Active Mode on the NetWare tab.
Depending on the mode selected, the procedure following will be different.
Proceed to the corresponding page.
For directory service:
when NDS Print Server or NDS Remote Printer is selected for Active Mode
(See "Configuring in Directory Service (NDS)", p.103)
For bindery service:
when Bindery Print Server or Bindery Remote Printer is selected for Active
Mode (See"Configuring in Bindery Service", p.112)
102
In this case, click No, and then check and ensure that the power of
the printer is switched on or the Ethernet cable is properly connected.
check with the administrator of the printer. Or you can click Yes, and
the Input Community dialog box will be displayed. If you enter the
correct community name, the Configure dialog box will be displayed.
Advertisement
Table of Contents
