Xerox DocuPrint 305 User Manual page 80

TBCP Filter
Specifies whether to enable or disable the TBCP filter when processing PostScript data.
This item is displayed when the PostScript software kit (optional) is installed. The default is
[Disable].
SMB
Select this to use SMB.
Port Status
Specifies whether to enable or disable the SMB port when the printer turns on. The default
is [Enable], which means the SMB port is available.
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
Transpt Protocol
Specifies the transport protocol used for SMB. NetBEUI, TCP/IP, or both protocols can be
specified. The default is [TCP/IP].
Note
• When using TCP/IP, both the IP addresses of a computer and the printer are required.
Print Mode
Sets the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type. [PS] is
displayed only when the PostScript software kit (optional) is installed.
PJL
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
TBCP Filter
Specifies whether to enable or disable the TBCP filter when processing PostScript data.
This item is displayed only when the PostScript software kit (optional) is installed. The
default is [Disable].
80
4 Settings on the Control Panel
*1 (refer to P. 95)
*2 (refer to P. 95)