Xerox DocuPrint 305 User Manual page 79

*3 (refer to P. 95)
Connect Time-Out
Specifies the time interval for disconnection when no further data is received. You can
specify a value between 2 and 3600 seconds in increments of 1 second. The default is [16
Secs].
TBCP Filter
Specifies whether to enable or disable the TBCP filter when processing PostScript data.
This item is displayed when the PostScript software kit (optional) is installed. The default is
[Disable].
Port No.
Sets 515 or a value between 8000 and 9999 for the port number. The default is [515].
NetWare
Select this to use NetWare.
Port Status
Specifies whether to enable or disable the NetWare port when the printer turns on. The
default is [Disable]. To use NetWare, select [Enable].
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
Transport Protocol
Specifies the transport protocol used for NetWare. IPX/SPX, TCP/IP, or both protocols can
be specified. The default is [TCP/IP,IPX/SPX].
Note
• When using TCP/IP, both the IP addresses of a computer and the printer are required.
*1 (refer to P. 95)
Print Mode
Specifies the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type. [PS] is
displayed only when the PostScript software kit (optional) is installed.
*2 (refer to P. 95)
PJL
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
*3 (refer to P. 95)
No. of Searches
Specifies how many times the file server is searched.
Specify a value between 1 and 100 in increments of 1, or select [No Limit]. The search
interval is 1 minute. The default is [No Limit].
4.2 Description of Menu Items
79