Xerox DocuPrint 305 User Manual page 125

Replacing the Drum/Toner Cartridge
1. Remove any output paper and open cover
A.
Note
• When the offset catch tray (optional) is installed, fold
the tray first before opening cover A.
Important
• Do not touch any parts inside the printer.
2. Hold the drum/toner cartridge by the grip
and pull it out slowly.
Note
• To prevent the toner from dirtying the floor, lay a piece
of paper on the floor first before putting the drum/toner
cartridge down.
3. Take the new drum/toner cartridge out of
the packaging box and shake it 7 to 8 times
as shown in the diagram.
Important
• If the toner is not evenly spread out, the print quality
may be reduced. Also, if you did not shake the drum/
toner cartridge well, there may be operating noise or
the interior of the cartridge may be damaged during
operation.
• Do not touch the surface of the photosensitive drum.
4. Place the drum/toner cartridge on a flat
surface and pull out the seal horizontally.
Important
• When pulling out the seal, pull it out horizontally. The
tape might break if it is pulled out diagonally.
• After the seal has been pulled out, do not shake or
bump the drum/toner cartridge.
6.1 Replacing the Drum/Toner Cartridge
125