Acura 2007 RL Owner's Manual page 215

STEREO ICON BAND
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or the AM/FM
button (AM or FM button on
Canadian and Hawaiian models).
Adjust the volume by turning the
power/volume knob.
The band and frequency that the
radio was last tuned to are shown on
the display. To change bands, press
the AM/FM button (AM or FM
button on Canadian and Hawaiian
models). You can also change bands
by pushing the interface selector up.
Each time you push it up, the band
will change to FM1, FM2, or AM. On
the FM bands, STEREO will be
shown on the navigation screen and
ST on the upper display, if the
station is broadcasting in stereo.
Stereo reproduction on AM is not
available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band:
TUNE, SEEK, SCAN,
preset buttons, and AUTO SELECT
TUNE ICON
Use the TUNE button to
TUNE
tune the radio to a desired frequency.
Press the button to tune to a
higher frequency, or the
to tune to a lower frequency. To tune
with the interface dial, push the
the selector down, and turn the knob to
. TUNE. Then press ENTER on the
selector, and turn the knob to the
desired frequency. To exit the
TUNE mode, press ENTER on the
selector.
Audio System
button
CONTINUED
209