Co Line Configuration - Vodavi Starplus Triad-S Installation Manual

4-12
Chapter 4 - Maintenance and Troubleshooting

CO Line Configuration

Figure 4-4
in that slot and:
The installer types d<space>s2 at the maint> prompt.
Column
1
2
3
4
5
6
7
illustrates a representation of what is printed out for slot two when a LCOB is installed
Figure 4-4: CO Line Configuration
Indicates:
CO Line Number
Status:
OOS status can indicate the entire card is out of service.
INS status can indicate a board station is in-service and operating
correctly.
Incoming = Incoming CO line calls are allowed
Outgoing = Outgoing CO line calls are allowed
Bothway = Both incoming and outgoing CO line calls are allowed
For example, Outgoing Enabled indicates the CO line is active in the system.
Outgoing Disabled indicates that the Attendant has disabled the CO line for
outgoing access.
CO Line Group Number
CO Line Type:
0 = None
1 = Data
2 = Loop Start
3 = Ground Start
4 = DID
5 = TIE
6 = TIE-DNIS
7 = TIE-ANI
Whether CO Line is Pulse or DTMF (programmable option)
Whether CO Line is a CO Line or a PBX Line (programmable option)
CO line State
Remote Maintenance