Measuring and Storing Angle ADC
1. Select
The board reappears, with the
2. Move the cursor to point
The point is marked with an ×.
3. Move the cursor to point
The point is marked with an ×.
4. Move the cursor to point
The angle,
dotted line on the object.
5. Select
main Geoboard commands reappear.
TI-73 Geoboard
(press the key), and then select
MEAS
, appears, and the angle is shown as a
123.69
to store the value in the calculator's
L
2
prompt.
Angle
, and then press the E key.
A
, and then press the E key.
D
, and then press the E key.
C
.
Angle
list. The
L
2
Page 12