Manual Rcv Mode (Factory Setting); Friendly Reception - Panasonic UF-E1 User Manual

Receiving Documents
This section explains the 4 types of reception modes in which you can set your apparatus. (See page 38)
This mode allows you to speak to the other party before receiving a document.
Handset

Friendly Reception

This function enables automatic fax reception even when the handset is lifted. (See notes 3, 4 and 5)
Lift up the handset when it rings.
(See note1) (See note2) (See note3)
Note:
A black square mark will be printed on the top right corner of the received paper for the apparatus to
check the print quality. It is possible to change to not print this mark by the setting of #07 in the FAX
SETTING. (See pages 81 and 84)
NOTE
40
MANUAL RCV Mode
START
(See note4) (See note5)
1. If a document is placed in your apparatus when you press [START], your apparatus will switch
to fax transmission. To receive faxes, remove the doument and press [START].
2. An incoming call will be cut off when you replace the handset before pressing [START].
3. To use this function, set "FRIENDLY RCV" to "ON". (See pages 81 and 84)
4. Sometimes friendly reception is not possible if you hear noise over the handset. When this
happens, press [START] to start reception.
5. Your apparatus will not automatically switch to reception if 30 seconds has elapsed without
receiving fax tone after lifting up the handset.
1
The apparatus starts to ring.
2
Lift up the handset and ask the other party
to send the document.
3
START
4
Replace the handset. (See note 2)
Reception starts automatically.
-Replace the handset.
PICKUP TELEPHONE
* TELEPHONE *
Reception starts. (See note 1)
ON LINE * RCV *
Reception ends.