Nortel Alteon OS 42C4911 Application Manual page 151

Each time you add a port to a VLAN, you may get the following prompt:
Port 4 is an untagged port and its current PVID is 1.
Confirm changing PVID from 1 to 2 [y/n]?
Enter y to set the default Port VLAN ID (PVID) for the port.
3. Add each IP interface to the appropriate VLAN.
Now that the ports are separated into three VLANs, the IP interface for each subnet must be
placed in the appropriate VLAN. From
lows:
>> VLAN 3# /cfg/l3/if 1
>> IP Interface 1# vlan 2
>> IP Interface 1# ../if 2
>> IP Interface 2# vlan 1
>> IP Interface 2# ../if 3
>> IP Interface 3# vlan 1
>> IP Interface 3# ../if 4
>> IP Interface 4# vlan 3
4. Apply and verify the configuration.
>> IP Interface 5# apply
>> IP Interface 5# /info/vlan
>> Information# port
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
5. Save your new configuration changes.
>> Information# save
42C4911, January 2007
Table 8-3 on page 150, the settings are made as fol-
(Select IP interface 1 for def. routers)
(Set to VLAN 2)
(Select IP interface 2 for first floor)
(Set to VLAN 1)
(Select IP interface 3 for second floor)
(Set to VLAN 1)
(Select IP interface 4 for servers)
(Set to VLAN 3)
(Make your changes active)
(View current VLAN information)
(View current port information)
(Save for restore after reboot)
Chapter 8: Basic IP Routing
Alteon OS Application Guide
151