Nortel Alteon OS 42C4911 Application Manual page 11

Figures
Figure 1-1:Switch management on the BladeCenter management module 26
Figure 1-2:BOOTP Relay Agent Configuration 30
Figure 1-3:DHCP Relay Agent Configuration 31
Figure 2-1:Authenticating a Port Using EAPoL 69
Figure 3-1:Default VLAN settings 81
Figure 3-2:Port-based VLAN assignment 82
Figure 3-3:802.1Q tagging (after port-based VLAN assignment) 82
Figure 3-4:802.1Q tag assignment 83
Figure 3-5:802.1Q tagging (after 802.1Q tag assignment) 83
Figure 3-6:Example 1: Multiple VLANs with VLAN-Tagged Gigabit Adapters 85
Figure 4-1:Port Trunk Group 94
Figure 4-2:Port Trunk Group Configuration Example 97
Figure 5-1:Using Multiple Instances of Spanning Tree Group 111
Figure 5-2:Implementing Multiple Spanning Tree Groups 112
Figure 7-1:QoS Model 124
Figure 7-2:Layer 3 IPv4 packet 134
Figure 7-3:Layer 2 802.1q/802.1p VLAN tagged packet 139
Figure 8-1:The Router Legacy Network 145
Figure 8-2:Switch-Based Routing Topology 146
Figure 8-3:DHCP Relay Agent Configuration 154
Figure 11-1:iBGP and eBGP 172
Figure 11-2:Distributing Network Filters in Access Lists and Route Maps 175
Figure 11-3:BGP Failover Configuration Example 182
Figure 11-4:Route Aggregation and Default Route Redistribution 185
Figure 12-1:OSPF Area Types 189
Figure 12-2:OSPF Domain and an Autonomous System 190
Figure 12-3:Injecting Default Routes 197
Figure 12-4:OSPF Authentication 200
Figure 12-5:A Simple OSPF Domain 205
Figure 12-6:Configuring a Virtual Link 207
Figure 12-7:Summarizing Routes 211
Figure 13-1:Basic Layer 2 Failover 220
Figure 13-2:Two trunks, each in a different Failover Trigger 221
42C4911, January 2007 11