Handling Sd Memory Cards; Performing Operations On Sd Memory Cards - Panasonic AJ-PX5100G Operating Instructions Manual

Handling SD memory cards

The SD memory card can be removed and inserted, either before or after the power is turned on.
Inserting SD memory cards
1
Open the slot cover.
2
Insert the card into the SD memory card slot with the label side of the SD memory card (optional) upward, and close the slot
cover.
@
NOTE
t The SD memory card must be inserted with the correct side facing the SD card slot. If the SD memory card is hard to insert, it may be reversed or
upside-down. Do not force it into the slot. Check the orientation of the card before re-inserting it.
t On the camera, use SD memory cards that are compliant with the SD, SDHC or SDXC standards.
t For details on handling SD memory cards, refer to "Cautions when using SD memory cards" (page 24).
Removing SD memory cards
After opening the slot cover and making sure that the busy lamp is not illuminated, push the SD memory card further into the main unit and then release.
This releases the SD memory card from the card slot. Remove the SD memory card and close the slot cover.
Note the following points when using or storing memory cards.
f Avoid high temperature and humidity.
f Avoid water droplets.
f Avoid charging with electricity.
Store the SD memory card with the card still inserted into the camera and with the slot cover closed.

Performing operations on SD memory cards

To perform operations such as formatting an SD memory card, writing setting data to an SD memory card, or reading the written data, perform
[FORMAT SD CARD] and [SETUP DATA (SD CARD)] in the main menu → [FILE].
If the SD memory card that was formatted in a standard other than the SD/SDHC/SDXC standards on a device other than the camera is inserted,
[LOAD] or [SAVE] operation of the file cannot be performed. Format the SD memory card again.
Formatting SD memory cards
1
Select main menu → [FILE] → [FORMAT SD CARD], and press the jog dial button (or <SET> button).
The confirmation screen is displayed.
2
Select [YES] in the confirmation screen, and press the jog dial button (or <SET> button).
To not format the memory card, select [NO], and press the jog dial button (or <SET> button).
3
When the completion message is displayed, select [OK], and press the jog dial button (or <SET> button).
For details on error messages, refer to "Warning/error displays in the thumbnail operation, menu operation, and USB storage mode" (page 251).
Chapter 4 Shooting — Handling setting data
– 119 –