Direct Call; Setting The Direct Call Mode; Dialing The Stored Number - Panasonic KX-TCD961CXB Operating Instructions Manual

KX-TCD961CXB(28~33)

Direct Call

You can easily make a call using a stored direct call number by pressing
accepted.

Setting the Direct Call Mode

After storing the direct call number, the unit will automatically switch to the direct call mode.
When the direct call mode is on, you can ONLY dial the number stored in the direct call memory.
1
Press
Press G or F until " F42 " is displayed.
2
3
Press .
OK
F42 -
If the current stored number is the same
as the number you wish to set, skip to
step 5.
4
Enter the phone number, up to 24 digits.
If you misdial, press
erased from the right. To erase all digits,
press C firmly.
5
Press
A confirmation tone sounds.
The display will return to the stand-by
mode, then "
- i -

Dialing the Stored Number

Make sure that "
The number stored in the direct call memory is dialed automatically.
30
99.12.3 2:15 PM Page 30
.
C . The digits are
.
" is displayed.
" is displayed, then press
. Incoming calls are
To change the direct call number:
Enter the new direct call number in step 4.
To turn OFF the direct call mode
1
Press .
Press G or F until " F42 " is displayed.
2
3
Press .
OK
4
Press .
" " will go out.
.