Toshiba e-STUDIO190F Operator's Manual page 117

No. Parameter
159 SUBJECT LINE ENTRY
160 DEFAULT DOMAIN
161 DNS SERVER
163 ROUTING HEADER
164 IFAX XMT HEADER
(Email only)
168 CC/BCC STATION
169 DHCP CLIENT
170 SMTP
AUTHENTICATION
(See page 118, Note 3)
171 POP BEFORE SMTP
(See page 118, Note 3)
172 DIRECT IFAX XMT
173 DELIVERY NOTICE
(HOME)
174 APOP
AUTHENTICATION
(See Note 3)
Setting Setting
Number
*1 Invalid Selecting whether the "Subject" line can be
programmed during each transmission.
2 Valid
1 Invalid Selecting whether the machine accepts to insert the
Default Domain when entering Manual Number Dialing.
*2 Valid
1 Invalid Selecting whether to use the DNS Server for the
Internet communication.
*2 Valid
*1 Invalid Selecting whether to add the Header Print information of
the Routing Station on the top edge of each routed pages.
2 Valid
*1 Included Selecting whether to include the header when sending
a document to an addressee in the same Domain as
2 Not included
specified in the Default Domain parameter. (This is
useful when using the machine to scan documents
back to your PC)
*1 Invalid Selecting whether to allow the CC/BCC email
address(es) to be entered.
2 Valid
1 Invalid Select whether the machine would automatically
acquire the Network Parameters from the DHCP
*2 Valid
Server. (Such as IP Address, Subnet Mask, Default
Gateway IP Address,etc.)
*1 Invalid If you transmit to the SMTP server, user name and
password are used for authentication. Selecting "Valid"
2 Valid
allows you to set up the user name and password.
*1 Invalid If you transmit to the SMTP server, POP user name
and POP password are used for authentication.
2 Valid
*1 Invalid Selecting whether to be prompted during Phone Book
registration if the station you are programming is to
2 Valid
receive Internet Fax directly without going through a
Mail Server.
*1 Off Setting the home position of whether to request a
Message Disposition Notification (MDN) for a delivery
2 On
processing confirmation indicating that the message
(email) was read, when sending an email/Internet Fax.
This setting will be the default value for the Function
Select Mode (F8-2).
*1 Invalid This parameter allows you to encrypt the protocol for
the POP password security when connecting with the
2 Valid
POP server.
Comments
Note: When sending to a Domain other than as
specified in the Default Domain parameter, the
header will be included regardless of the
selection.
Note: If you change the setting of this parameter, the
machine will reboot automatically.
117