Learning Commands; Clearing Commands; Master Clear - Universal Remote Control ZC800 Owner's Manual

Learning Commands

1. Press and hold the SETUP button until the red
indicator turns on, then release the button.
2. Press and release the desired mode button (TV,
DVD, etc.), the red indicator blinks then stays on.
3. Press and release the LEARN button, the red
indicator blinks then stays on.
4. Press and release the Learning Remote button that
you want to teach (e.g. POWER).
5. Point both remotes facing each other by approxi-
mately 1 inch apart (see tips on page 13).
6. Press and hold the Original Remote button (e.g.
Power) until the red indicator blinks once and stays
on. If there is a learning problem, the indicator blinks
for three seconds and stays on. If this happens,
repeat Steps 4 to 6.
7. Repeat Steps 4-6 for other buttons you want to
learn.
8. Press and release the SETUP button when all desired
remote commands are learned. Code Learning is now
complete.
6.
Line up your remotes (that you're learning from) in front of
the Learning remote, on a hard surface approx. 1 inch apart.
1.
2.
16

Clearing Commands

To Clear all Learned Commands under a mode
1. Press and hold the SETUP button until the red
indicator turns on. Release the SETUP button.
2. Press and release the button for the mode you want
to clear (TV, DVD, etc.). The red indicator blinks off.
3. Press and release the LEARN button TWICE. The
red indicator blinks off.
4. Press and release the SETUP button. The red
indicator turns off. All learned Commands under that
mode are now cleared.
Master Clear - To Clear all Learned
Commands under all modes
1. Press and hold the SETUP button until the red
indicator turns on. Release the SETUP button.
2. Press and release the LEARN button TWICE. The
red indicator blinks off.
3. Press and release the SETUP button. The red
indicator turns off. All Learned commands in the
remote are now cleared.
4.
3.
17