Attaching The Cap Frame - Baby Lock Embroidery Professional PLUS BMP9 Instruction And Reference Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Pull the mounting jig toward you, and then use
the Phillips screwdriver to tighten the four
screws (two on the left and two on the right).
This completes the preparation of the
mounting jig.

Attaching the cap frame

→
Touch
in order to view a video of the operation on the
LCD (refer to page 204).
Put the cap into the cap frame attached to the
mounting jig, and then remove the cap frame from
the mounting jig with the cap clamped. Next,
attach the cap frame to the cap frame driver on the
machine.
230
■ Attaching the cap frame to the mounting jig
1
→ →
2
and putting a cap into the frame
Attach the cap frame to the mounting jig.
Align the side of the mounting jig with the
brace on the cap frame, and then push the
cap frame into place.
1 Side of mounting jig
2 Brace on cap frame
3 Guiding Plate on mounting jig
4 Notch on cap frame
5 Sweat guard holder
6 Holder
• Align the notch in the cap frame with the
guiding plate on the mounting jig, and then
snap the frame into place.
The cap frame is secured with the two
holders (clips) one on right side and one
on left side.
Release the snap lock on the cap frame down
and then disengage the latch. Open the
clamping frame. Also, open brim holder.
1 Snap lock released
2 Clamping frame opened
3 Brim holder