Winding The Bobbin - Baby Lock Embroidery Professional PLUS BMP9 Instruction And Reference Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Winding the bobbin

Prepare the bobbin and the spool of bobbin thread.
Use cotton or spun polyester bobbin thread (from
74 dtex/2 to 100 dtex/2).
1 Align the groove in the bobbin with the
spring on the bobbin winder shaft, and set
the bobbin on the shaft.
1 Groove in the bobbin
2 Spring on the shaft
2 Set the thread spool on the spool pin.
1 Thread spool
2 Spool pin
240
Note
● When using a small spool, remove the
spool cushion and set the spool directly
onto the spool pin. Also use the included
spool cap to keep the small spool stable.
3 Pass the thread through the hole in the left of
the thread guide toward the front of the
winder.
1 Hole in the thread guide
4 Pass the thread around the tension disc as
shown in the illustration. Make sure that the
thread is correctly fed into the tension disc.
1 Tension disc