Turning On The Machine - Baby Lock Embroidery Professional PLUS BMP9 Instruction And Reference Manual

EMBROIDERING TUTORIAL

2. Turning ON the Machine

Connect the power supply cord, and then turn on the embroidery machine. For precautions concerning the
power supply, refer to page 32.
1 Plug the power supply cord into the
machine.
2 Insert the plug of the power supply cord into
a household electrical outlet.
3 Switch on the main power switch on the
back of the machine to "I".
The LCD screen comes on.
4 When the machine is turned on, the opening
movie is played. Touch anywhere on the
screen to display the message below.
38
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
5 Touch .
The pattern type selection screen appears,
and the start/stop button lights up in red.
6 The carriage moves to its initial position.
• If the number 1 needle bar is not already at
the embroidering position, the needle bar
case moves and the number 1 needle bar
moves to the embroidering position.
CAUTION
●
Make sure to keep your hands and
other items away from the carriage, in
order to prevent any injuries.
Memo
● If the machine is turned off in the middle
of embroidering, the machine will
automatically save the design position
when turned on again. At that time, you
will be asked if you wish to continue
embroidering or begin a new operation.
(Refer to "Resume Embroidering After
Turning Off the Machine" on page 110.)