Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
The memory capacity of the USB
media has been exceeded.
There is too much data in either the
machine or the USB media.
The image is going to be deleted.
A saved combined pattern is being
rotated in the embroidering
settings screen.
was touched in the
embroidering screen.
Touch
to return to the
embroidering settings screen. The
previous embroidery in the
embroidering screen will be
canceled.
The machine was turned off while
sewing, then turned on again.
Touch
to return the
machine to the condition (pattern
position and number of stitches)
when it was turned off. Follow the
procedure described in "Resume
Embroidering After Turning Off the
Machine" on page 110 to align the
needle position and sew the
remainder of the pattern.
The thread picker did not operate
correctly.
Remove the thread entangled on
the thread picker.
The selected pattern is going to be
deleted because
was
touched.
was touched while thread
colors were being changed.
The thread trimming button was
pressed while a screen other than
the embroidering screen or
embroidering settings screen was
displayed.
Display either the embroidering
screen or embroidering settings
screen before using the thread
trimming function.
Troubleshooting 261
7
Advertisement
Table of Contents
Troubleshooting
