Admin Functions; Acct; Admin; Apear - Avaya IP Office 44/46/64xx User Manual

Page 28 - Admin Functions

Admin Functions

The following can be programmed against a DSS key via the Admin function (see
Programming Functions Against DSS Keys on page 26.

Acct

Make a call using an account code or enter an account code during a call. This function
can be programmed with or without data.
Note: Any account code entered must match a valid code stored on the telephone
system. If a matching code does not exist, RENTER ACCOUNT is displayed when the
DSS key is used.
If programmed without an account code, the telephone user is able to enter the code to
use after pressing the DSS key.
AD
Dial a stored number. This function requires entry of a number to dial when
programmed. The number does not have to be a complete number, after pressing the
DSS key the user can dial additional digits to complete dialing.

Admin

Allows the programming of the functions in this section against other DSS keys. This
function can be programmed with or without data.
If programmed without data see Programming Functions Against DSS Keys on page
26.
If programmed with a value of 1, see Programming Using the ProgA Menu on page

Apear

Set a DSS key to act as an additional call appearance key. For users with call waiting
enabled or using call coverage this allows them to handle multiple calls, holding and
switching between calls using call appearance keys. This function does not require any
data entered when programmed.

AutoCB

Sets a callback when free on a called busy extension and a callback when next used
on a called but unanswered extension. This function does not require any data entered
when programmed. When a callback is set the appropriate DSS key lamp is lit. The
DSS key can be pressed again to cancel the callback.
[break]

CFrwd

Switch call forwarding on/off and set the forwarding number. This function can be
programmed with or without a target forwarding number.
If programmed with a forwarding number, pressing the appropriate DSS key switches
forwarding to that number on.
If programmed without a forwarding number, pressing the appropriate DSS key
prompts the user to set a forwarding number and then switch call forwarding to that
number on.
In both cases, while call forwarding in on the appropriate DSS key lamp is lit and
pressing the DSS key again switches call forwarding off.
Page 28 - DSS Key Functions
Admin Functions
44/46/64xx & TransTalk MDW 9040 User's Guide
40DHB0002UKEG – Issue 10 (9th February 2004)
DSS Key Functions
31.