Secondary Ethernet (Hub) Interface Enable/Disable - Avaya 4600 Series Installation Manual

Secondary Ethernet (Hub) Interface Enable/Disable

Use the following procedure to enable or disable the hub interface.
The default for the hub interface is enabled.
1. While the phone is on-hook and idle, press the following sequence of keys on the faceplate of
the telephone:
Mute 4 6 8 # (Mute I N T #)
Press the Mute button momentarily. Do not press this button while pressing other keys/
buttons. The 4630 IP Telephone does not have a dedicated Hold button; for all other
4600 Series IP Telephones, pressing the Hold button instead of the Mute button will also
work.
One of the following texts is displayed left-justified at the top of the display, depending on the
current value of the hub:
If PHY2=enabled:
If PHY2=disabled:
2. Press the 1 or 0 button to enable or disable the hub interface respectively, or the # button to
leave the current value.
The following text is displayed left-justified at the top of the display:
Save new value?
*=no #=yes
Press the * button to terminate the procedure, or the # button to save the new values. If you
press the # button, the following text is displayed.
New value
being saved
The new values are saved, and the user interface is restored to its previous state.
Chapter 3: Local Administrative Options
PHY2=enabled
0=disable #=OK
PHY2=disabled
1=enable #=OK
3
Static Addressing Installation
3-7