Platform Ring; Long Rail Adapter; System - ATN PS-40 Operator's Manual

B. Attach the remote control to the connector and secure with the
captive nut.
C. Place the remote switch on the fore-end of rifle stock and with
Velcro tape.
D. Turn the function switch in standby position (STB). To activate
the sight, press and hold the pressure switch.
E. After disconnecting the remote control, replace the cap onto
the connector.

2.3.4. PLATFORM RING

If the PS-40 is installed on MIL-STD-1913 rail, optional platform ring
is used for mounting optional IR illuminator on dayscope having
mounting diameter 25.4 or 30 mm (see Figure 2-3).
Attach the platform ring to your dayscope as follows:
A. Unscrew the two screws securing top and bottom halves of the
platform ring.
B. If the diameter of your scope tube is 30 mm, remove plastic
inserts.
C. Place the top and lower parts of the platform ring around the
dayscope tube.
D. Secure the two screws set using screwdriver. Do not apply ex-
cessive torque.

2.3.5. LONG RAIL ADAPTER

Optional long rail adapter can be used if the firearm has a short
scope mounting rail which prevents the installation of the PS-40
forward of dayscope (See Figure 2-3).
2.3.6. B.A.M. SYSTEM
Optional B.A.M. system (Boresight Attachment Mount) is used to
install the PS-40 and dayscope on the rifles having short mounting
MIL-STD-1913 rail. There are three advantages of the system:
• Low position of the sight and dayscope (36 mm above the
rail).
2-13